.028 ohm Data Line Filters 5

Reset All

Part	Manufacturer	Filter Type	Construction	Maximum DC Resistance	Maximum Frequency	Material	Rated Current	No. of Functions	Output Impedance (ohm)	Packing Method	Mounting Type	No. of Terminals	Sub-Category	Dimensions	Case Code	Maximum Operating Temperature	Minimum Operating Temperature	Terminal Finish	Height	Width (mm)	Additional Features	JESD-609 Code	Minimum Frequency	Length
FBMH4532HM681-T	Taiyo Yuden	FERRITE CHIP	Chip Bead	.028 ohm	100 MHz	Ferrite	4 A	1	680 OHM	TR, EMBOSSED	SURFACE MOUNT	2	Other Passive Filters	L4.5XB3.2XH3.2 (mm)/L0.177XB0.126XH0.126 (inch)	1812	125 Cel	-40 Cel	TIN OVER NICKEL	3.2 mm	3.2	RECTANGULAR CHIP; HIGH IMPEDANCE TYPE	e3	100 MHz	4.5 mm
FCFBMH4532HM681-T	Taiyo Yuden	FERRITE CHIP		.028 ohm			4 A	1	680 OHM	TAPE AND REEL	SURFACE MOUNT	2		L4.5XB3.2XH3.2 (mm)/L0.177XB0.126XH0.126 (inch)		85 Cel	-40 Cel		3.2 mm		HIGH IMPEDANCE TYPE			4.5 mm
LSMGA453232L681RG	Taiyo Yuden	FERRITE CHIP		.028 ohm			4 A	1	680 OHM	TR, 13 INCH	SURFACE MOUNT	2				125 Cel	-40 Cel		3.2 mm	3.2				4.5 mm
FBMH1608HL300-T	Taiyo Yuden	FERRITE CHIP	Chip Bead	.028 ohm	100 MHz	Ferrite	2.5 A	1	30 OHM	TAPE AND REEL	SURFACE MOUNT	2	Other Passive Filters	L1.6XB0.8XH0.8 (mm)/L0.063XB0.031XH0.031 (inch)	0603	85 Cel	-40 Cel		.8 mm	0.8	RECTANGULAR CHIP; HIGH IMPEDANCE TYPE		100 MHz	1.6 mm
LLMGA453232L681RG	Taiyo Yuden	FERRITE CHIP		.028 ohm			4 A	1	680 OHM	TR, 13 INCH	SURFACE MOUNT	2				125 Cel	-40 Cel		3.2 mm	3.2				4.5 mm

Data Line Filters

Data line filters are electronic filters that are used to filter out noise and interference from data communication lines. They are designed to provide a high level of attenuation of unwanted frequencies while allowing the desired data signal to pass through with minimal distortion.

Data line filters use a combination of passive and active components, including resistors, capacitors, inductors, and op-amps, to filter out noise and interference from data communication lines. They can be designed for a wide range of communication standards, including Ethernet, USB, HDMI, and other data communication protocols.

Data line filters can be designed as low-pass filters, which allow low-frequency signals to pass through while attenuating high-frequency signals, or as band-stop filters, which block a specific range of frequencies while allowing other frequencies to pass through. They can also be designed with multiple stages of filtering to provide increased attenuation of unwanted frequencies.

Data line filters are commonly used in a variety of electronic systems, including computers, telecommunication equipment, medical equipment, and industrial control systems. They are also used in data centers and other applications where high-speed data communication is critical.