.04 ohm Data Line Filters 99

Reset All
Part RoHS Manufacturer Filter Type Construction Maximum DC Resistance Maximum Frequency Material Rated Current Minimum Insulation Resistance Approvals (V) Power Supply (V) No. of Functions Technology Screening Level Output Impedance (ohm) High Pot Packing Method Mounting Type Rated Voltage No. of Terminals Sub-Category Dimensions Case Code Maximum Operating Temperature Attenuation At Maximum Frequency Minimum Attenuation Frequency Package Material Minimum Operating Temperature Attenuation At Minimum Frequency Terminal Finish Inductance Maximum Attenuation Frequency Manufacturer Series Height Width (mm) Diameter (mm) Maximum Insertion Loss Additional Features JESD-609 Code Minimum Frequency Operating Frequency (Hz) Series Length Capacitance

AME28461Y/HB

Infineon Technologies

DATA LINE FILTER

.04 ohm

30 A

2

PANEL MOUNT

28 V

12

L2.5XB1.5XH0.38 (mm)/L0.098XB0.059XH0.015 (inch)

125 Cel

-55 Cel

.38 mm

1.5

2.5 mm

40000 uF

AME50461Z/HB

Infineon Technologies

DATA LINE FILTER

.04 ohm

30 A

2

HYBRID

THROUGH HOLE MOUNT

50 V

12

Data Line Filters

125 Cel

METAL

-55 Cel

40000 uF

AME28461X/HB

Infineon Technologies

DATA LINE FILTER

.04 ohm

30 A

2

PANEL MOUNT

28 V

12

L3.0XB1.5XH0.38 (mm)/L0.118XB0.059XH0.015 (inch)

125 Cel

-55 Cel

.38 mm

1.5

3 mm

40000 uF

Data Line Filters

Data line filters are electronic filters that are used to filter out noise and interference from data communication lines. They are designed to provide a high level of attenuation of unwanted frequencies while allowing the desired data signal to pass through with minimal distortion.

Data line filters use a combination of passive and active components, including resistors, capacitors, inductors, and op-amps, to filter out noise and interference from data communication lines. They can be designed for a wide range of communication standards, including Ethernet, USB, HDMI, and other data communication protocols.

Data line filters can be designed as low-pass filters, which allow low-frequency signals to pass through while attenuating high-frequency signals, or as band-stop filters, which block a specific range of frequencies while allowing other frequencies to pass through. They can also be designed with multiple stages of filtering to provide increased attenuation of unwanted frequencies.

Data line filters are commonly used in a variety of electronic systems, including computers, telecommunication equipment, medical equipment, and industrial control systems. They are also used in data centers and other applications where high-speed data communication is critical.