33 ohm Data Line Filters 4

Reset All
Part RoHS Manufacturer Filter Type Construction Maximum DC Resistance Maximum Frequency Material Rated Current Minimum Insulation Resistance Approvals (V) Power Supply (V) No. of Functions Technology Screening Level Output Impedance (ohm) High Pot Packing Method Mounting Type Rated Voltage No. of Terminals Sub-Category Dimensions Case Code Maximum Operating Temperature Attenuation At Maximum Frequency Minimum Attenuation Frequency Package Material Minimum Operating Temperature Attenuation At Minimum Frequency Terminal Finish Inductance Maximum Attenuation Frequency Manufacturer Series Height Width (mm) Diameter (mm) Maximum Insertion Loss Additional Features JESD-609 Code Minimum Frequency Operating Frequency (Hz) Series Length Capacitance

ECLAMP2456P.TCT

Semtech

DATA LINE FILTER

33 ohm

6

TAPE AND REEL

SURFACE MOUNT

5 V

12

Data Line Filters

L3.1XB1.7XH0.65 (mm)/L0.122XB0.067XH0.026 (inch)

85 Cel

40 dB

PLASTIC

-40 Cel

Nickel/Palladium/Gold (Ni/Pd/Au)

.028 uH

2700 MHz

ECLAMP2456P

.65 mm

1.7

e4

3.1 mm

12 uF

NUF2101W1T1

Onsemi

DATA LINE FILTER

33 ohm

1

TAPE AND REEL

SURFACE MOUNT

L2.2XB1.35XH1.1 (mm)/L0.087XB0.053XH0.043 (inch)

125 Cel

-55 Cel

NUF2101W1T1

1.1 mm

2.2 mm

STF202-30T1

Onsemi

DATA LINE FILTER

33 ohm

1

TAPE AND REEL

SURFACE MOUNT

L3.1XB1.7XH1.1 (mm)/L0.122XB0.0669XH0.0433 (inch)

STF202-30T1

1.1 mm

1.7

3.1 mm

SPUSB1CJT

Littelfuse

DATA LINE FILTER

33 ohm

UL; IEC

2

45 OHM

TAPE AND REEL

SURFACE MOUNT

5.5 V

6

L2.25XB1.35XH1.0 (mm)/L0.089XB0.053XH0.039 (inch)

85 Cel

-40 Cel

TIN LEAD

1 mm

1.35

BAG

e0

2.25 mm

47 uF

Data Line Filters

Data line filters are electronic filters that are used to filter out noise and interference from data communication lines. They are designed to provide a high level of attenuation of unwanted frequencies while allowing the desired data signal to pass through with minimal distortion.

Data line filters use a combination of passive and active components, including resistors, capacitors, inductors, and op-amps, to filter out noise and interference from data communication lines. They can be designed for a wide range of communication standards, including Ethernet, USB, HDMI, and other data communication protocols.

Data line filters can be designed as low-pass filters, which allow low-frequency signals to pass through while attenuating high-frequency signals, or as band-stop filters, which block a specific range of frequencies while allowing other frequencies to pass through. They can also be designed with multiple stages of filtering to provide increased attenuation of unwanted frequencies.

Data line filters are commonly used in a variety of electronic systems, including computers, telecommunication equipment, medical equipment, and industrial control systems. They are also used in data centers and other applications where high-speed data communication is critical.