1200 MHz Data Line Filters 1

Reset All

Part	RoHS	Manufacturer	Filter Type	Construction	Maximum DC Resistance	Maximum Frequency	Material	Rated Current	Minimum Insulation Resistance	Approvals (V)	Power Supply (V)	No. of Functions	Technology	Screening Level	Output Impedance (ohm)	High Pot	Packing Method	Mounting Type	Rated Voltage	No. of Terminals	Sub-Category	Dimensions	Case Code	Maximum Operating Temperature	Attenuation At Maximum Frequency	Minimum Attenuation Frequency	Package Material	Minimum Operating Temperature	Attenuation At Minimum Frequency	Terminal Finish	Inductance	Maximum Attenuation Frequency	Manufacturer Series	Height	Width (mm)	Diameter (mm)	Maximum Insertion Loss	Additional Features	JESD-609 Code	Minimum Frequency	Operating Frequency (Hz)	Series	Length	Capacitance
74279225101		Wurth Elektronik	FERRITE CHIP	Chip Bead	.004 ohm	1200 MHz	Ferrite	10 A				1			100 OHM		TAPE AND REEL	SURFACE MOUNT		2	Other Filters	L8.5XB3.05XH2.28 (mm)/L0.335XB0.12XH0.09 (inch)	3312	125 Cel				-55 Cel						2.28 mm	3.05					100 MHz			8.5 mm

Data Line Filters

Data line filters are electronic filters that are used to filter out noise and interference from data communication lines. They are designed to provide a high level of attenuation of unwanted frequencies while allowing the desired data signal to pass through with minimal distortion.

Data line filters use a combination of passive and active components, including resistors, capacitors, inductors, and op-amps, to filter out noise and interference from data communication lines. They can be designed for a wide range of communication standards, including Ethernet, USB, HDMI, and other data communication protocols.

Data line filters can be designed as low-pass filters, which allow low-frequency signals to pass through while attenuating high-frequency signals, or as band-stop filters, which block a specific range of frequencies while allowing other frequencies to pass through. They can also be designed with multiple stages of filtering to provide increased attenuation of unwanted frequencies.

Data line filters are commonly used in a variety of electronic systems, including computers, telecommunication equipment, medical equipment, and industrial control systems. They are also used in data centers and other applications where high-speed data communication is critical.