.37 A Data Line Filters 10

Reset All

Part	Manufacturer	Filter Type	Maximum DC Resistance	Rated Current	Minimum Insulation Resistance	No. of Functions	Screening Level	Output Impedance (ohm)	Packing Method	Mounting Type	Rated Voltage	No. of Terminals	Dimensions	Maximum Operating Temperature	Minimum Operating Temperature	Terminal Finish	Height	Width (mm)	Additional Features	JESD-609 Code	Length
744232090	Wurth Elektronik	DATA LINE FILTER	.3 ohm	.37 A		2		90 OHM	TAPE AND REEL	SURFACE MOUNT	50 V	4	L3.2XB1.6XH1.9 (mm)/L0.126XB0.063XH0.075 (inch)	125 Cel	-40 Cel		1.9 mm	1.6			3.2 mm
744231091	Wurth Elektronik	DATA LINE FILTER	.3 ohm	.37 A		2		90 OHM	TAPE AND REEL	SURFACE MOUNT	50 V	4	L2.0XB1.2XH1.2 (mm)/L0.079XB0.047XH0.047 (inch)	125 Cel	-40 Cel	Tin (Sn)	1.2 mm	1.2		e3	2 mm
ACM2012-121-2P-T002	TDK	FERRITE CHIP	.22 ohm	.37 A	10 Mohm	2		120 OHM	TR, 7 INCH	SURFACE MOUNT	50 V		L2.0XB1.2XH1.3 (mm)/L0.079XB0.047XH0.051 (inch)	85 Cel	-40 Cel		1.3 mm	1.2			2 mm
ACM2012-121-2P-T001	TDK	DATA LINE FILTER	.22 ohm	.37 A		2	AEC-Q200	120 OHM	TAPE AND REEL	SURFACE MOUNT	50 V	4	L2.0XB1.2XH1.3 (mm)/L0.079XB0.047XH0.051 (inch)	105 Cel	-40 Cel		1.3 mm	1.2			2 mm
DLW21SN121SQ2L	Murata Manufacturing	DATA LINE FILTER	.45 ohm	.37 A	10 Mohm	2		120 OHM	TAPE AND REEL	SURFACE MOUNT	50 V	4	L2.0XB1.2XH1.2 (mm)/L0.079XB0.047XH0.047 (inch)	85 Cel	-40 Cel	TIN	1.2 mm	1.2	COMMON MODE CHOKE	e3	2 mm
DLW31SN900SQ2L	Murata Manufacturing	DATA LINE FILTER	.3 ohm	.37 A	10 Mohm	2		90 OHM	TAPE AND REEL	SURFACE MOUNT	50 V	4	L3.2XB1.6XH1.9 (mm)/L0.126XB0.063XH0.075 (inch)	85 Cel	-40 Cel	TIN NICKEL	1.9 mm	1.6	MAGNETICALLY SHIELDED ONE CIRCUIT TYPE	e2	3.2 mm
744231121	Wurth Elektronik	DATA LINE FILTER	.3 ohm	.37 A		2		120 OHM	TAPE AND REEL	SURFACE MOUNT	50 V	4	L2.0XB1.2XH1.2 (mm)/L0.079XB0.047XH0.047 (inch)	125 Cel	-40 Cel	Tin (Sn)	1.2 mm	1.2		e3	2 mm
DLW31SN900SQ2	Murata Manufacturing	DATA LINE FILTER	.3 ohm	.37 A	10 Mohm	2		90 OHM		SURFACE MOUNT	50 V		L3.2XB1.6XH1.9 (mm)/L0.126XB0.063XH0.075 (inch)	85 Cel	-40 Cel	TIN	1.9 mm	1.6	COMMON MODE CHOKE	e3	3.2 mm
DLW31SN900SQ2B	Murata Manufacturing	DATA LINE FILTER	.3 ohm	.37 A	10 Mohm	2		90 OHM	BULK	SURFACE MOUNT	50 V	4	L3.2XB1.6XH1.9 (mm)/L0.126XB0.063XH0.075 (inch)	85 Cel	-40 Cel	TIN	1.9 mm	1.6	BAG	e3	3.2 mm
BLF03JD421GZED	Murata Manufacturing	FERRITE CHIP	.28 ohm	.37 A		1	AEC-Q200	420 OHM	TR, PAPER, 7 INCH	SURFACE MOUNT		2		125 Cel	-55 Cel		.4 mm	0.3	IMPEDANCE AT 700 MHZ		.6 mm

Data Line Filters

Data line filters are electronic filters that are used to filter out noise and interference from data communication lines. They are designed to provide a high level of attenuation of unwanted frequencies while allowing the desired data signal to pass through with minimal distortion.

Data line filters use a combination of passive and active components, including resistors, capacitors, inductors, and op-amps, to filter out noise and interference from data communication lines. They can be designed for a wide range of communication standards, including Ethernet, USB, HDMI, and other data communication protocols.

Data line filters can be designed as low-pass filters, which allow low-frequency signals to pass through while attenuating high-frequency signals, or as band-stop filters, which block a specific range of frequencies while allowing other frequencies to pass through. They can also be designed with multiple stages of filtering to provide increased attenuation of unwanted frequencies.

Data line filters are commonly used in a variety of electronic systems, including computers, telecommunication equipment, medical equipment, and industrial control systems. They are also used in data centers and other applications where high-speed data communication is critical.