30 A EMI Mains Filters 14

Reset All

Part	Manufacturer	Filter Type	Maximum Frequency	Rated Current	Minimum Insulation Resistance	Approvals (V)	Insertion Loss At Minimum Frequency	High Pot	Maximum Leakage Current	Packing Method	Mounting Type	Rated Voltage	Dimensions	Maximum Operating Temperature	Insertion Loss At Maximum Frequency	Minimum Operating Temperature	Manufacturer Series	Height	Width (mm)	Diameter (mm)	Additional Features	Minimum Frequency	Operating Frequency (Hz)	Length
RTEN-5030D	TDK	THREE PHASE EMI FILTER		30 A	100 Mohm	UL; EN		2500 V	5 mA		PANEL MOUNT	500 V	L140.0XB70.0XH50.4 (mm)/L5.512XB2.756XH1.984 (inch)	85 Cel		-25 Cel		50.4 mm	70.0				60Hz	140 mm
RTEN-5030	TDK	THREE PHASE EMI FILTER		30 A	100 Mohm	UL; EN		2500 V	5 mA		PANEL MOUNT	500 V	L140.0XB70.0XH42.0 (mm)/L5.512XB2.756XH1.654 (inch)	85 Cel		-25 Cel		42 mm	70.0				60Hz	140 mm
FN3258-30-33	Schaffner Holding Ag	THREE PHASE EMI FILTER		30 A		UL; CSA; ENEC-14		2650 V	33 mA		PANEL MOUNT	480 V	L240.0XB50.0XH85.0 (mm)/L9.449XB1.969XH3.346 (inch)	100 Cel		-25 Cel		85 mm	50.0		TERMINAL BLOCK CONNECTIONS		60Hz	240 mm
NBH-30-681-D	Cosel	SINGLE PHASE EMI FILTER		30 A		UL; CSA; VDE; ENEC-10		2500 V	.15 mA		DIN RAIL MOUNT	250 V	L104.0XB53.0XH43.0 (mm)/L4.094XB2.087XH1.693 (inch)	85 Cel		-40 Cel	NBH	43 mm					60Hz	104 mm
30DKCS5	Delta Electronics	SINGLE PHASE EMI FILTER		30 A		UL; CSA; VDE		2250 V	2 mA		PANEL MOUNT	250 V	L74.7XB51.8XH39.1 (mm)/L2.941XB2.039XH1.539 (inch)					39.1 mm	51.8				50/60Hz	74.7 mm
NBH-30-681	Cosel	SINGLE PHASE EMI FILTER		30 A		UL; CSA; VDE; ENEC-10		2500 V	.15 mA		CHASSIS MOUNT	250 V	L104.0XB53.0XH43.0 (mm)/L4.094XB2.087XH1.693 (inch)	85 Cel		-40 Cel	NBH	43 mm					60Hz	104 mm
30VSB6	TE Connectivity	SINGLE PHASE EMI FILTER	30 MHz	30 A		UL; CSA; VDE	3 dB	2250 V	.22 mA		PANEL MOUNT	250 V	L100.254XB52.58XH38.86 (mm)/L3.947XB2.07XH1.53 (inch)	40 Cel	42 dB	-10 Cel		38.86 mm	52.58			.3 MHz	50/60Hz	100.254 mm
SCR29XV-300-2R4A005JV	KEMET Corporation	SINGLE PHASE EMI FILTER		30 A	100 Mohm					TRAY	THROUGH HOLE MOUNT	1000 V		120 Cel		-40 Cel		37.7 mm	21.4		AEC-Q200			41.5 mm
1609989-3	TE Connectivity	THREE PHASE EMI FILTER		30 A		UL; VDE		1850 V	33 mA		PANEL MOUNT	277 V	L240.0XB50.0XH85.0 (mm)/L9.449XB1.969XH3.346 (inch)	50 Cel		-10 Cel		85 mm	50.0				50/60Hz	240 mm
30AYP6C	TE Connectivity	THREE PHASE EMI FILTER	30 MHz	30 A		UL; CSA; VDE	15 dB	1450 V	3.4 mA		PANEL MOUNT	250 V	L224.0XB141.5XH65.0 (mm)/L8.819XB5.571XH2.559 (inch)	40 Cel	50 dB	-10 Cel		65 mm	141.5		STUD TERMINAL; GROUND CHOKE	.05 MHz	50/60Hz	224 mm
30DKCS5B	Delta Electronics	SINGLE PHASE EMI FILTER		30 A		UL; CSA; VDE		2250 V	2 mA		PANEL MOUNT	250 V	L95.0XB56.5XH46.4 (mm)/L3.74XB2.224XH1.827 (inch)					46.4 mm	56.5				50/60Hz	95 mm
30AYT6C	TE Connectivity	THREE PHASE EMI FILTER	30 MHz	30 A		UL; CSA; VDE	29 dB	1450 V	3.4 mA		PANEL MOUNT	250 V	L351.0XB141.5XH65.0 (mm)/L13.819XB5.571XH2.559 (inch)	40 Cel	60 dB	-10 Cel		65 mm	141.5		STUD TERMINAL; GROUND CHOKE	.05 MHz	50/60Hz	351 mm
30VSK6	TE Connectivity	SINGLE PHASE EMI FILTER		30 A		UL; CUL; VDE		2250 V	.75 mA		PANEL MOUNT	250 V	L125.0XB79.25XH69.85 (mm)/L4.921XB3.12XH2.75 (inch)	40 Cel		-10 Cel		69.85 mm	79.25		STUD TERMINAL		50/60Hz	125 mm
SC-30-12JH	KEMET Corporation	SINGLE PHASE EMI FILTER		30 A	100 Mohm	UL		500 V		TRAY	THROUGH HOLE MOUNT	250 V		105 Cel		-25 Cel		40 mm		65

EMI Mains Filters

EMI mains filters are electronic filters that are used to suppress electromagnetic interference (EMI) from mains power lines. They are designed to provide a high level of attenuation of unwanted frequencies while allowing the desired power signal to pass through with minimal distortion.

EMI mains filters use a combination of passive and active components, including capacitors, inductors, resistors, and diodes, to filter out noise and interference from power lines. They can be designed for a wide range of power ratings and frequencies, depending on the application.

EMI mains filters can be designed as low-pass filters, which allow low-frequency power signals to pass through while attenuating high-frequency EMI signals, or as band-stop filters, which block a specific range of frequencies while allowing other frequencies to pass through. They can also be designed with multiple stages of filtering to provide increased attenuation of unwanted frequencies.

EMI mains filters are commonly used in a variety of electronic systems, including power supplies, motor drives, medical equipment, and industrial control systems. They are also used in residential and commercial buildings to suppress EMI noise from power lines and prevent interference with other electronic devices.