50 A EMI Mains Filters 7

Reset All

Part	Manufacturer	Filter Type	Rated Current	Minimum Insulation Resistance	Approvals (V)	High Pot	Maximum Leakage Current	Packing Method	Mounting Type	Rated Voltage	Dimensions	Maximum Operating Temperature	Minimum Operating Temperature	Height	Width (mm)	Diameter (mm)	Additional Features	Operating Frequency (Hz)	Length
FMAD-0934-5010	Schurter Ag	THREE PHASE EMI FILTER	50 A		UL; CUL; VDE; ENEC-10	3000 V	5 mA		PANEL MOUNT	480 V	L201.0XB121.0XH66.0 (mm)/L7.913XB4.764XH2.598 (inch)	100 Cel	-25 Cel	66 mm	121.0		INDUCTANCE 0.8 MILLIHENRY	50/60Hz	201 mm
SCR29XV-050-1R0A044JH	KEMET Corporation	SINGLE PHASE EMI FILTER	50 A	100 Mohm				TRAY	THROUGH HOLE MOUNT	1000 V		120 Cel	-40 Cel	21.9 mm	37.2		AEC-Q200		39 mm
DKIH-3358-50D7-NK	Schurter Ag	THREE PHASE EMI FILTER	50 A		IEC; UL	3740 V			THROUGH HOLE MOUNT	600 V		100 Cel	-40 Cel	31 mm		58		0-400Hz
6609069-6	TE Connectivity	SINGLE PHASE EMI FILTER	50 A				7 mA		PANEL MOUNT	250 V		40 Cel	-10 Cel
6609069-7	TE Connectivity	SINGLE PHASE EMI FILTER	50 A				3.9 mA		PANEL MOUNT	250 V		40 Cel	-10 Cel
FN356-50-33	Schaffner Holding Ag	THREE PHASE EMI FILTER	50 A		UL; CSA; ENEC-14	2000 V	.43 mA		PANEL MOUNT	440 V	L142.5XB122.0XH102.0 (mm)/L5.61XB4.803XH4.016 (inch)	100 Cel	-25 Cel	102 mm	122.0			60Hz	142.5 mm
50FC10	TE Connectivity	SINGLE PHASE EMI FILTER	50 A		UL	2250 V	7 mA		PANEL MOUNT	250 V		40 Cel	-10 Cel	64.77 mm	139.2			50-60	150.9 mm

EMI Mains Filters

EMI mains filters are electronic filters that are used to suppress electromagnetic interference (EMI) from mains power lines. They are designed to provide a high level of attenuation of unwanted frequencies while allowing the desired power signal to pass through with minimal distortion.

EMI mains filters use a combination of passive and active components, including capacitors, inductors, resistors, and diodes, to filter out noise and interference from power lines. They can be designed for a wide range of power ratings and frequencies, depending on the application.

EMI mains filters can be designed as low-pass filters, which allow low-frequency power signals to pass through while attenuating high-frequency EMI signals, or as band-stop filters, which block a specific range of frequencies while allowing other frequencies to pass through. They can also be designed with multiple stages of filtering to provide increased attenuation of unwanted frequencies.

EMI mains filters are commonly used in a variety of electronic systems, including power supplies, motor drives, medical equipment, and industrial control systems. They are also used in residential and commercial buildings to suppress EMI noise from power lines and prevent interference with other electronic devices.