10 RF/Microwave Mixers 3

Reset All
Part RoHS Manufacturer RF or Microwave Device Type Mounting Feature No. of Terminals Package Body Material Technology Screening Level Maximum Input Power (CW) Maximum Voltage Standing Wave Ratio Maximum Supply Current Construction Power Supplies (V) Package Equivalence Code Characteristic Impedance Sub-Category Maximum Operating Temperature Minimum Operating Temperature Terminal Finish Maximum Conversion Loss Additional Features JESD-609 Code Minimum Operating Frequency Maximum Operating Frequency

LTC5562IUC#TRMPBF

Analog Devices

DOUBLE BALANCED

SURFACE MOUNT

10

PLASTIC/EPOXY

15 dBm

46 mA

COMPONENT

3.3

LCC10,.08SQ,20

50 ohm

105 Cel

-40 Cel

MATTE TIN

e3

.03 MHz

7000 MHz

LTC5562IUC#PBF

Analog Devices

DOUBLE BALANCED

SURFACE MOUNT

10

PLASTIC/EPOXY

15 dBm

46 mA

COMPONENT

LCC10,.08SQ,20

50 ohm

105 Cel

-40 Cel

MATTE TIN

e3

0 MHz

9000 MHz

PMB2335

Infineon Technologies

TRIPLE BALANCED

SURFACE MOUNT

10

PLASTIC/EPOXY

BIPOLAR

COMPONENT

2.7/4.5

TSSOP10,.19,20

50 ohm

RF/Microwave Mixers

85 Cel

-40 Cel

Tin/Lead (Sn/Pb)

LOW NOISE

e0

3000 MHz

RF/Microwave Mixers

RF/microwave mixers are electronic devices used in radio frequency (RF) and microwave systems to convert one frequency to another. They perform frequency translation by multiplying two input signals, a local oscillator (LO) signal and a radio frequency (RF) or intermediate frequency (IF) signal, to produce an output signal that has the sum and difference frequencies of the inputs.

RF/microwave mixers are commonly used in a variety of applications, including frequency conversion, phase detection, modulation and demodulation, and signal generation. They are widely used in telecommunications, radar systems, navigation systems, and satellite communication systems.

RF/microwave mixers are available in various types, including diode mixers, transistor mixers, and monolithic microwave integrated circuit (MMIC) mixers. The choice of mixer depends on the application requirements, such as the desired frequency range, signal bandwidth, conversion gain, and noise figure.